SEFIS Flow Duo LED turn lights - rear pair

SEFIS resistor relay 311N led turn signal indicator

2.70 € Ex Tax: 2.24 €

SEFIS turn signals extension M8 2pcs

4.90 € Ex Tax: 4.06 €

SEFIS turn signals extension M10 2pcs

4.90 € Ex Tax: 4.06 €

SEFIS extension wiring for turn signal 20cm 2pcs

2.00 € Ex Tax: 1.69 €

Cable connector 30cm 2pcs

The harness connector is used to easily connect to any wiring on the bike without having to cut or cut the original wiring. It is suitable for all common wires with a diameter of 1.5 - 2 mm and is used, for example, when installing blinkers, additional lights, alarms, etc. to "stab" into the original electrical wiring of the motorcycle. If you remove the punch-through connector again, we recommend re-insulating the cable in the place where the punch-through connector was connected, for example with electrician's insulating tape.<br /> <br /> <br /> How to use: <ol> <li>Unscrew the gray cover of the piercing terminal.</li> <li>Insert the cable to which you want to connect the connector into the groove in the gray cover of the piercing terminal. The connector is suitable for use with ordinary cables with a diameter of 1.5 – 2 mm.</li> <li>Screw the red punch-through end with the extension cable onto the gray cover of the punch-through terminal with the cable and make sure that the connected cable is firmly fixed.</li> </ol>

2.70 € Ex Tax: 2.24 €

SEFIS thread adhesive locker glue - medium strength

<strong>Instructions for use - </strong>Apply to the thread and immediately tighten. The glue will fully harden within 24 hours.

1.60 € Ex Tax: 1.34 €

SEFIS Faston socket - round connector 4mm with insulation - female - 10 pcs

2.00 € Ex Tax: 1.69 €

SEFIS set Faston - round connector 4mm with insulation - male and female - 10 pcs

3.30 € Ex Tax: 2.72 €